Recent content by HannibalLecter

that was the point, next will be a 3d printed titanium slider for the stand hehe

Yeah the clamp is cnc machined and it cost too much lol. Re flipping e bikes the best solution would be a worm gear and a motorised stand

Ask and you shall receive I need a horizontal reinforcement plate, between the two legs and no one seems to provide online laser servises in Germany. Also, a different clamping axle as the one I have is too short, but the cnc service says they cannot accommodate that. Weird, as they made the...

Custom made manual bike stand, cause I cannot stand the available ones lol

Yeah, burgers per bald eagles would be better, I know 😂

Yeah, not dropping 600€ on a Fein cordless and its not my profession, rather my obsession. The cord is long enough lol

A very Fein drill, made in Germany

Hazet 916HPLG

May,but nowadays chains are so narrow that they may not fit in the teeth that hold them aligned on the tool

Yep that's it. I don't care about the pin but it is spring loaded so it can accommodate every chain

If you want a really quirky one and nit that expensive Hozan C 271

Yep, wera and pb, or maybe facom

Pb swiss

Wow serious investment. As for the clik valves, once you try you never wanna go back. Only hassle is when you have to change a tube you have to unscrew and rescrew the valve core

I think they were the newer ones, with ratchets, brand new wheels. Off the wheel the preload ok, with the wheel on the bike binding. This was definitely wrong tolerances. My dt 240 without grease are ok, after 6k kms. However could be better