Recent content by hevnbnd

Thanks guys I got it working. I now have it tied into my Control4 Automation system. Have a remote I can kick it on with, buttons on my keypads, can use Alexa, and also have contacts on my gates so when they open it turns on.

I can also trip it by slowing it down using the frequency knob.

I get the error no longer how far out I set it. I think it is set to 3600 seconds now. The error comes within 2 seconds of turning off vfd. The error appears to show at the same time no matter how far out I set the DECEL time.

Thanks guys. That fixed me right up. Now If I could get rid of the pesky E07.2 error message. It comes up ever time I shut down the unit. I tried extending the DECEL time for the default 10 seconds to like 75 seconds. It didn't change anything. It throws an error like 2 seconds after shutdown...

So almost 8 years later I am finally wiring this up.... :rocker: If anyone has any advice I could use it. I have the Hitachi VFD mentioned above. I have it setup with a program I think is correct. I get 250V across all terminals and 120v to ground on each leg. When I hit ON on the Delta Dust...

I added link. Does it work for you?

https://imgur.com/a/3dVdr4i Can anyone tell what model this is from the picture? I don't know much about Bendpak. What do you think it is worth? Is about 5 years old. Thanks Also I am not sure i see the IMG test above my post but i don't see the image... Do you guys see the image?

Thanks for the great reply. Actually the only reason I was looking at Snorkel was their https://www.snorkellifts.com/equipment/category/Scissor-Lifts/Electric-Scissor-Lifts/s3019e This one has all electric drive motors as well. The stack also sinks into the base. I would be buying a new one so...

Thanks for the information. I think i am getting a Snorkel. They have one that is all electric. NO hydraulics. Anyone have any experience with Snorkel?

I have had one for two years. Just sold it and looking to replace it.

Hopefully someone knows more about these than me. Looking at a newish scissor lift either a Genie 1930 or JLG 1930ES. Anyone have any experience with these?

What did you use for your base of your lift? IE the piece that the materials going up sit on?

Your post.... Totally agree.

Thanks for the input. Ended up with a Multiquip MVC88VTHW. It is a little smaller than I would like but it came with an Honda GX160 motor and water tank.

Only thing what is good for? 3050 is not even designed for asphalt. It has not water tank. We use crusher dust for fill most of the time.