Hohn's latest activity

Not you, the OP suggested it. You are bang on correct IMO. I was agreeing with you. But awkwardly 😬

Eric Smidt

I'm not sure that concluding all blades are junk from a sample size of one HF product is valid.

Seems more like to me that galvanic corrosion between the galvanized ****** and the brass is to blame. It's amazing how nobody seems to...

I should post up sometime what I found inside the wall of my 2005-build house. I'm sure they cut every corner possible now that I've...

QFT. Slow the heat entrance. Radiate the heat outward instead of inward. Seal out the warm air ingress. Add thermal breaks where...

With nearly two decades in my current house, I can tell you that staying in a house long enough means you will have a Fernco in a couple...

Wise observation that there's more to a lift than just its stated weight capacity. There might be other good reasons to want a larger lift.

These guys where where I was leaning until I did a bit more research. Then I came to think @MoonRise is bang on. The only reason to use...

You know, this reminds me of the perpetual debate in my family about the performance of some key players on our favorite sports team--...

No to the first and no to the second. Do NOT pressurize to double the WP and definitely do not use a pressure washer.

I could be wrong but what I think you're seeing is a Kalamazoo belt grinder that someone has modified to be driven by a grinder. It's...

ASME standards for NEW pressure vessels use 1.3 MAWP. Since this is old and of uncertain upkeep, I would not exceed that value. Without...

Not 2x MAWP!! At best 1.3x MWAP. Yes, it needs to be water filled. Not sure of the 90% amount but it is very high. Water is...

Yes, but that’s not a Champion pump.