Recent content by houdni

i started piecing when i had my certiflat table...ive been buying a little at a time so it doesnt hit me too hard in the wallet.... on the side note....ive noticed the certiflat table have gotten some bigger sizes...not to mention you can now buy them in different thickness... before the fab...

sorry folks...i broke down....and decided to upgrade....the certiflat table is a very good introduction table as well as value of what these tables are capable of.... if you do decide to get these table....youll have to figure out how to lift them up....this one is 1200 lbs....just something to...

amateur das why... :lol_hitti

if you can ever find this coupler...this one was the best one i have found...the top will is a universal clip adapter to multiple type of couplers...theres no air pressure until you slide the bottom half up... to release...slide down the slide releases the air...push the release coupler at the...

to make

Hope your a millionaire....everyone living in Hawaii is...

Matco's extra long set....hard to beat... expensive? Yes...but worth it!

Is imgur free? Or do you pay for an account to host your images? If it's free...perhaps you've overused your free bandwith to show pics.... Photobucket does this ...someone has to help pay for the server to store your pics

Kart axles...pillow blocks...and even gears for a chained motor

heres the receptacle im using for my welder.. powers a synchrowave 250

i have pneumatics...just dont have 1/2" lines to supply a 3/4" gun the proper air to break the bolt...so when you dont have air...gotta do it the old fashioned way :)

36" snap on with a little more for that stubborn honda crank bolt

i believe he mentioned when the top gets worn...it could get replaced....thus a renewable top... a lot cheaper than replacing a super thick plate...

Look at your local car shops...see what they use...also look in your area for lift companies that sell lifts...parts and also repairs...this will help you when you might need to get a hold of parts... or even repairs

Feel free to post up your table builds and comments/opinions on the table