Recent content by imgoin

I put together a set from Albany County Fasteners. 2",3"&6" are available. While i had a list going with them, put together a hex set also in metric and sae.

Looks like a Ramsey RE 8000. Pierce winch in Henrietta Texas has a winch that looks the same. Ive used their solenoids and 12 volt motors to keep mine going. Its considered a worm drive winch. Not as fast as the planetary gear winches but dependable as long as you let it cool down on hard pulls.

I like to hang my combination wrenches. Quicker access. SAE on top and metric on bottom.

Gear 90 seems to be the one I use the most. I will bring ring gears in the house and cook them in the oven for a few minutes, to make install and alignment easier. There was a time I would get yelled at. Now she shakes her head with no words. Nothing like baked potatoes with a hint of gear 90...

I bought the Woodward fab wfbr23, it's a motorized bead roller. It's a Chinese turd. Doesn't work, would not pull the 18 ga sheet metal in, much less put a bead in it. I wish I would have taken the time and built my own.

I recently ordered a bead roller from woodward fab, about 4 weeks ago. About 3weeks later it shows up. Anxiously, I mounted the motorized bead roller to the stand, and plugged the machine up to 110 volt 60 hz outlet, as spec'd. I punched the button to roll the dies thru, got familiar with the...

I ran across this website. http://www.metalbythefoot.com/onlinestore-5.html This looks very nice, a fantasy table. Ouch, $7400 welding table.

I hang my wrenches on metal hook panels.

I had this cool VW hub cap I found on the side of the road. That would make a cool clock.