Recent content by In4lo

Hahaha that's a good one!

Working on a new set of sliders for the truck. Learning to bend tube has been a whole adventure in itself. Notched it a little long and need to go back and renotch it.

The new 211's are tiny compared to the last model.

Getting my Rogue Fab tube bender put together the past couple nights. Fly couldn't say no to the bright blue light.

Thanks, definitely want to move up to a TIG machine but would like to gain more experience with MIG first.

Good info! I was looking at some other welds I did last night and was thinking I ought to tighten up a bit and this confirms that. I knew better than to leave the ends open :anon: Thanks for the input!

I used cursive "e's" whipped back into the puddle technique. No tack, tack, tacks here. I'm open for all constructive criticism as well since I've only been welding with a gas shielded machine for 2 months.

Steering spindle gussets for a Toyota Tacoma.

Finished my welder cart up this past weekend.

211 cart, just finished painting it this afternoon.