Recent content by J Adams

FYI, in case anyone cares, I have come across an original Snap On **** O Scope operators manual. These are about as rare as any collectable item I've never seen! Does anyone out there have a need for one? I've been thinking about reproducing it.

I've been told that the handle does not come apart from the bracket and I think that's probably true. The result is that I will buff and polish it until I get as bright a finish as I can. Oh Well..

I did! Sprayed some Kroil penetrating oil on it

That's the question!! I don't know! If I did know, I could figure out how to take it apart! Look closely at the close up photo of the handle and you can see marks from my Vise-Grips where I tried to twist the handle to see if it was threaded together. It wouldn't budge. Really don't want to...

I live in the Portland OR area, similar climate to you, and have hydronic floor heat in my custom built house. Best decision I ever made. It's fired by a standard 80% efficient natural gas water heater, 3 zones. Very low operational cost, it operates October through May/June. Worst decision I...

Great comments! Anyone have any knowledge of how to get that handle apart?

I am starting the restoration of the Master Analyzer, the Snap On Scope, and the KRA-315 roll cab. One problem that's to be figured out is how to remove the chrome handle from its mount so I can rechrome it. See photos. Anybody out there know if it is possible? Help!! John Adams

Planning on doing a full restoration, repaint, rebuild everything

I recently purchased a vintage Snap On Master Analyzer that included 4 meters and an **** O Scope oscilloscope. Planning to restore them. I would appreciate anybody out there who has any knowledge/experience with these to please post here with any thoughts/comments. I know, the name....but hey...

I noticed that as well. Where in the manual does it describe the internal power source for the memory?

Just an FYI to the folks out there! The Portland Oregon Swap Meet takes place this weekend at the Portland Expo Center, I will have a booth there for my business, which is college licensed auto products like decals and license plate frames with college logos on them. In this case, Oregon Ducks...

For the past few weeks I have been accumulating various bits and pieces for my MT 3000A Counselor 2. I have also found three more Counselors that I bought locally for some of the accessories that I intend to clean up and resell. I will have a booth at the upcoming Portland Swap Meet in April...

Thanks for replying! No worries, I'm doing the same thing. I just acquired a box of misc. leads and have more coming. I plan to get familiar with the use of all this stuff on my Caddy starting in a few weeks when the weather starts to get better and I get it out of the garage. I am going to have...

Certainly willing to pay a fair price!!

BTW, I looked at your post of all the goodies you have a saw that you have 2 of the vacuum sensors. If you aren't using them I would appreciate either one or both of them heading my way...... Interested? Please? John Adams