Recent content by j3rf

Welcome from Ohio!

They've been out for a month or two I think. Wonder if they're compatible with the Snap On/Mac/Matco/Cornwell branded ones, which I suspect are made by CTA or Redline Detection based on similarity of design. As I already have the Mac vacuum filler, pressure tester and related adapter caps and...

I like the Microflex Midknight ones or the ones with the bumps for grip. Can't remember the OG brand though. Work provides Black Mamba brand and they're pretty good. Significantly better than the previous brand which was way too thin and tore super easily.

Yes, that's why I'm here!

@Madjik Man I've had excellent success with the Proto version of the Mac RBRT/Grip Edge RPT hex sockets on Subaru differential hex bolts. Clean out the rust and corrosion with a wire brush and pocket screwdriver, pound the bit home with a small hammer. Along with a long 3/8 ratchet, no heat...

https://www.amazon.com/LEATHERMAN-Titanium-Multitool-Replaceable-Stainless/dp/B079MJHYKC?tag=atomicindus08-20

Just arrived yesterday. Olight ArkPro.

Wonder how it's going... nine years later. :ROFLMAO:

I would say it depends on what job you need the cutters for. Knipex if you definitely need to cut through an L-shaped hex key for some reason. :LOL:

Use the same one at my Subaru dealer on our engine hoist for pulling engines.

I prefer the correct clamp, but I am not you.

Very interesting but probably won't fit where my PH3050 fits when doing Subaru wheel bearings. I still want it though.

I'm pretty open for scheduling whatever. August 14 would work for me. I do think a Friday would be a good day as well.

Probably be interested, would depend on time/date.

Another vote for Icon or Tekton split beam, whichever you can find cheaper.