Recent content by jackmcpilot

Here is a pcture of the shop with the new lift being rigged. I have a lot of framing for storage and a bathroom to do this winter. The next step before winter is to install a heater. I'm thinking of the infared tubes (Solaron)

I built a 40X60 pole barn with steel sides and roof. It is insulated except for skylights along the top of the walls. I wanted it large enough to keep a 27' sailboat in for the winter and also for resale if someone wants to store a large motorhome. It has two 14'high overhead doors in the...

I built the jig out of 2x4s with 1/2 inch plywood top, I lifted the posts on the jig with the end measurements and a chalk line and drilled the holes through the plywood. I then bolted the allthread to the plywood with nuts and washers top and bottom with 2.5 feet of allthread protruding below...

Hi, I just installed an XPR-10AC. I have not wired it yet or put Hydraulic fluid in so I still have to look forward to using it. I just built a new shop at my house and since I was pouring the floor I decided to use 2 and one half foot allthread into concrete and then poured the floor. I...