Recent content by Javahead

Im also looking for a metal router table to add to my Delta 10" Contractors Table saw so 27" wide. I would consider a trade depending on what you've got. BenchDog, Incra, Etc.

Ive got a General Mortise & Tenon Plunge Router Jig new & still in the box. Bought it but never got around to using it. Just upgraded a joinery system that allows me to do Mortise & Tenon so no need for a separate jig. I'll ship it for $90 total in the continental US. Paypal payment "Goods &...

I've got the Delta Unifence Saw Guide with rail that I just took off of my 10" Contractors Table Saw Platinum Edition. I upgraded to the Incra fence & joint system so I wont need the Unifence anymore. Great guide, the rail is 62" long. The fence has the ability to run upright or flat for smaller...

I will be. Havent run the wire from the main yet but I have the 4 wire ready.

Thanks Rodder98. Did that all today but then I realized that I was only leaving 1 neutral wire on the neutral bus & that threw me off. Also the fact that the previous owner of this CNC machine had this sub-panel wired without an isolated neutral really had me thrown off! I've never put those...

They are 250V grounded plugs so no neutral. Just making sure I was correct. As stated I have been reading through posts for the last month & I've read through all of the FAQ a few times. I just wanted to confirm that I was understanding it correctly. Thanks for pointing that out.

I'll add a 2nd grounding question. I'll also be running a different sub-panel to a detached building. I've added the 2 grounding rods, added a separate ground bus to the sub panel. All I need to do is run the 6 guage ground wire straight to that bus correct? When I wired my shop it was a metal...

Thats what I figured so the fact that 2 of the plugs have no neutral doesnt matter.

Been reading through a bunch of posts & I have 1 thing I want to confirm before I do something wrong. I'll start by saying Im no electricians. I do know what Im doing & I have an electrician on call just in case. I wired my whole shop & got my final inspection. But since then I've bought a CNC...

Yeah, I just saw the same thing. Rather stupid. Hope they fix this.

Showing back in stock again & with the 2nd item for 15% & right now I have a 10% Ebay Buck bonus, I went ahead & bought one of the regular ones & one of the XP ones. Total for the 2 shipped was less than $85 which doesnt seem too bad. Guess I'll see what the real difference between the 2 is.