Recent content by jaycoflyer

$250 to bury the conduit is great. I'll recommend the approach I took which is close to what you're thinkging as it was relatively inexpensive and I find it works awesome. Do the trench and conduit. Use GB ethernet cable long enough for single run from existing wifi router in your house to...

New Radiantec 4-loop Manifold (1/2" PEX). Never had fluid through it. Used in system to pressure check with air only during installation. Then subcontracted boiler install and contractor removed to use his own manifold. Regret not having him use this one which is much higher quality. :(...

It was my assumption that metal ceiling provides a vapor barrier. Maybe a bad assumption on my part. It IS already up and I should have had them install poly first but too late. Your suggestion about FACED batts with paper down is something I considered also. That might make the most...

Can't seem to find a discussion that covers my scenario, but if someone can point me to existing thread, I'll be happy to redirect. My 30x40x12 garage has heated floor, sheetrocked walls with R-21 (vapor barrier in). Ceiling is ribbed metal directly on attic trusses. My plan is to insulate...

Radiantec 4-Circuit Manifold Wall-Mount Style No fluids (only air) run through it All copper/brass. Very well constructed and includes schrader valvle for pressuring with guage. Designed to allow leak testing of tubing then simply cut off fill loop and plumb supply/return directly to the...

Drove about 80 miles round-trip to get this for $87 thanks to folks here. Was only one I could find within DC area. It’s quite nice and getting filled up fast. Sent from my iPad using Tapatalk

LoopCAD was used. Flow target is about 1 GPM for each loop. Delta T is supposed to be 20. My installer insisted on using 100% glycol which I think is a big mistake. From what I read, this lowers system performance (heat transfer) and makes circulators work harder likely reducing flow...

Have learned a great deal from reading all your posts. Had my system installed recently but not sure it's "dialed in" performance-wise. Hoping a few of you will be able to compare notes with me. I'm using LP tankless heater capable of 20K-125K BTU/h. Have 4 loops of 1/2 pex oxygen-barrier...

0-10V Dimming wire is run switch-fixture-fixture...? (All drivers in parallel) Sent from my iPad using Tapatalk

Thanks for posting the photo big country!! Used it to do a price match at my local store which was only half-off (this was 75% off). Great router for the price. Sent from my iPad using Tapatalk

Good to hear and thanks for tip. Agree...engine is awesome and well more than that alone. Good luck to others if looking for power washer! Sent from my iPad using Tapatalk

Saw this but inventory showed zero in stock everywhere but then up top is one in perfect box. Has my name on it being held. Anyone have experience with this one? Sent from my iPhone using Tapatalk

Westminster, MD at front entrance

I’m outfitting a garage of nearly identical dimensions (30x40x12’H). Reading through the threads, the consensus seemed to be that high-bay style lights such as these are better suited for higher mounting (14’ and up). And they’re advertised for 15’ and higher. I had nearly decided that the...

Re: 2018 Home Depot Clearance Thead Same here. Left about 15 for next guy. Thanks Chadman! Sent from my iPhone using Tapatalk