Recent content by jayfrank5074

Yes it can over discharge. The main leads are direct to the cells. The battery tells the tool to turn off. Take the battery apart and see if you want. Sent from my iPhone using Garage Journal

The last two kohler courage single cheap carbs I bought had to have the emulsion tube ball sealed up with fingernail polish and the main drilled so they would run properly. A kohler command 13hp I put a cheap carb on is now in the scrap and I found a used one to get going on it. With that...

A little update, I haven’t done anything. Dozer guy hasn’t came by yet. He is planning to come Saturday. I do think I need to get some water away from the house. There is one spot is collecting about 15 ft in front of the house. I need to address that. We have had so much rain, and its...

So a little back story. We bought this house 10 years ago. It had a little mold in the red area. Inspector said to bleach it and put a piece of plastic down. I did that. The porch is covered and is sealed very well to the brick. Very little water gets on the slab . I have checked this. I do...

I just thought about it, I have a nest thermostat I am not using, a 24vAC transformer and I would have an instant WiFi humidity and temperature monitor. I just wish IFTTT still worked with NEST like google said it would. Sent from my iPad using Garage Journal

According to the radon map, I am in the lowest area. I have never heard anyone around here talking about radon. I will look at water drainage around the house. We have had so much rain this year, everyone is having problems with it. I did put some extensions on the gutter downspouts. I’m...

So the radon pipes go on top of the ground and under the plastic? Sent from my iPad using Garage Journal

I apologize, I am in Mid-Mississippi. I have heard a lot about encapsulation, but never about radon under the plastic. The plastic is down and I am hesitant to remove it for any reason. We have lived in this house for 10 years, and last summer I found the mold. In January of last year, it...

Sorry double pic. Also I can’t add more vents behind the porch or the carport as they are solid concrete. Any other opinions on ceiling fan vs cross flow. If I put a ceiling fan down, I’d run it on low probably 8am to 6-7pm. After dark, I dont know that it would do any good. Maybe run 24/7...

I do have room for a ceiling fan down there. I didnt know if I needed to have the cross flow. I know a ceiling fan can pretty much run continuous for many years with no issues. I think the reason he said to run them above 50F is because even if humidity is higher, mold cant grow at low...

Good morning Everyone, I have an issue with my crawl space and need help figuring out the best way to solve it. Here is a drawing of my house crawl space. The area in red had some mold build up. It’s been cleaned, but I don’t want this issue again. I have since laid down 6mil plastic and taped...

Or use some 26650 cells, little spacer at the end? Sent from my iPhone using Garage Journal

I meant make a spacer towards the end, not the whole cell length. I think the m18 21700’s are rated at 35amp a cell. Pretty sure those 26700’s aren’t really any better. I just don’t think they were popular enough to be developed more. I’ve seen a lot of V18 lion and v28 lion batteries go bad...

Use some 21700 cells and make/find some spacers for the diameter difference. 21700 should be Super easy to find. Liionwholesale is a supplier I have used for 18650 before. Aren’t the new ryobi 3.0hp packs 21700? I looked a few months ago for 26700 and really only found old stock. Sent...

No, but would like to keep the humidity down in the separate storage room, and keep it above freezing. I usually leave the door open just a little to keep it from freezing. I only work in the 25x25.