Recent content by JCS1994

Or am I just reading it completely wrong and those readings for air delivery are more than adequate?

Hey guys, I am looking to buy my first large air compressor (looking at a 60 gallon Husky) to be able to use air tools but mostly to paint with HVLP guns. The advertised “SCFM” (I know I have always heard make sure you are not getting SCFM & CFM confused so that is why I am here) is 13.4 SCFM@40...

Hey guys, I am planning on building a fab table for my garage and had a couple of questions for y’all experts. If this is in the wrong thread, I apologize. I want to have a 36x36 area with metal grate for plasma/welding/grinding, etc and then extend another 12” off of that with just flat sheet...

I think even though it is extremely unsightly, I am going to just run a surface mount 650R outlet. There is a 120V outlet about 4’ off the ground right where I’d like to put my 220V. Is it still within code to have the 220 outlet directly below that around 2’ off the ground so I can just use the...

I would be using 6/2 or 8/2 Romex. And I have been seeing “old work low voltage boxes” and I am under the impression those are not for use with 220V. Is that correct or could I use one of those boxes and mount it in the drywall? I figure I will have to cut a hole in the drywall for a box...

Hey guys I just bought a welder that requires 220V input and it requires a 30A breaker and I am getting ready to get a 220V outlet installed in my garage but am planning on doing it myself but had some questions. So i have a recessed circuit breaker in the garage and an open attic that I can run...