Recent content by JeepJohn62

I replaced the board on mine a few years back. Mine is the HD75 model from 2002. I don't think it was that expensive, The old board had the time delay relays that failed over time. My other issue was that the flame sensor is located in the bottom of the unit. This also lines up with the...

The tube in tension will certainly provide sufficient strength. The connection would likely be the weak point. Maybe a short section of light cord or string could provide a safety shear point, so that if somebody gets hung up, the cord will snap before a severe injury occurs. Best wishes...

They would even fit inside the tube. A whole cricket battalion. Good point. Sent from my SM-A102U using The Garage Journal mobile app

Crickets. Sent from my SM-A102U using The Garage Journal mobile app

Curious. Why would you want to cantilever this tube for 7 feet? What is the intent or application? Sent from my SM-A102U using The Garage Journal mobile app

An Interesting question. My quick answer is not much. I ran this thru a deflection program which does not have a listing for this size and alloy. I will offer that a 2x2 3/16 wall Al square tube 6061 T6 alloy indicates a deflection of .154" with a 5 lb load. This assumes a fixed end...

Building some custom fuel tanks for my 96 Ford. The 460 is a great engine, but it is fond of fuel. Looking to increase my range with the truck camper. These will mount under the bed and alongside for transfer access. I should get about 35 gallons per side. Bent the 1/8" aluminum on a brake...

I have an Atlas 10K and it works for me. I have had F250 4x4. F350 Crewcab, and Ram 3500 on it with no problems. However, when you are working under a truck, more steel feels better. If I had more height, I can't say 12K would be out of the picture. I don't know if completely symmetrical...

Hi. I am in Palmer also. I have a Modine HotDawg gas heater in my shop. Many people have installed slab heating and like it. But for me, I like to crank the heat to 65 when I need it and turn it down to 50 or so when I don't. Keeps my paint and other stuff from freezing. The boiler and...

I am not fully understanding the final configuration you are looking for. Have you considered welding or riveting some 16 gauge sheet metal in place as a sheet metal doubler for the mounting supports? Just a thought. Best wishes. Sent from my SM-A102U using The Garage Journal mobile app

Here's one idea from Amazon. Sent from my SM-A102U using The Garage Journal mobile app

I will give you a good website reference called Polarwire.com. They are in Alaska and provide quality materials for extreme environments and marine equipment. They have some good reference info and you may be able to find a local supplier with similar products. I'm sure a local auto store...

I would explore wire at a marine supply store. More $$, but likely made for tougher environment. You only need a few feet. They usually offer a termination with heat shrink to seal out corrosion. Sent from my SM-A102U using The Garage Journal mobile app

Accusize is a good quality unit. Amazon works or check out Littlemachineshop.com. Sent from my SM-A102U using The Garage Journal mobile app

I haven't tried a DC resistance check before. Interesting. Is there a gfi outlet on the circuit, or are all just plain outlets? I wonder if a gci outlet would register a DC resistance to ground? Sent from my SM-A102U using The Garage Journal mobile app