Recent content by jetmechabq

  1. J

    Blue Thread locker "Loctite"

    yes, it has a shelf life yes i would trash it and start over. The shelf life of Permatex thread locker is typically 2 years when stored unopened at room temperature (46-82°F). Once opened, it is recommended to use it within 12 months. Factors such as temperature extremes, light exposure...
  2. J

    putting piers through existing patio slab

    cut and resurface with this https://coveryourugly.com/products/rubber-stone/
  3. J

    British standard pipe fittings

    go to a parker store
  4. J

    Looking for a Source for Butcher Block Bench Top

    try looking at floor and decor. https://www.flooranddecor.com/wood-butcher-block-countertops?shopThisStore=200
  5. J

    Snap-On What is it - maybe aviation related

    looks like a tool for the AMT appreciation day at that company.
  6. J

    Extension cord storage-pro tips

    Look at a carpenters wrap, some will call it a heavy gauge weave.
  7. J

    Safe room/tornado room in new construction basement garage?

    look at Liberty Safe Company. the doors are about 5K
  8. J

    Need some info on these tools!

    the red one is made by Norbar in the UK. we use them at work our are not torqued at we use them once we give a minimum torque we set to an angle to set the blade bearings on the propellers. the black bar is a reaction bar to assist with the torque. i know the big rigs use them for tire...
  9. J

    Aviation Grease Needle Fittings

    Most use a military spec grease or a manufactures spec grease and cost twice as much.
  10. J

    Harbour Freight Inside Track Club

    thanks everyone for the feedback I think ill wait. I just don't buy much stuff from HF anymore,
  11. J

    Harbour Freight Inside Track Club

    Anyone have an view good or bad on this club? When was the last time a discount was given for a 56 or 72 box? Or does it happen to be listed on the latest club coupons? Thanks Jetmech
  12. J

    Tool suggestions for a future A&P mechanic?

    Minimum Tool List 1 each Diagonal Cutters 2 each 3/16' through 3/4" wrenches, combination box-open end 12 point 1 each 13/16" wrench, combination box-open end 12 point 1 each 7/8" wrench, combination box-open end 12 point 1 each...
  13. J

    Buying Tools When Traveling Abroad (i.e. Europe)

    I did not find much difference in price but you will find a few thins that make you go OOOOO I see.
  14. J

    Tool box recommendations for future A&P mechanic

    look at the minimum tool listing that are out their is you have all of that then spend a good amount getting a school discount on a box. remember if you have to barrow a tool more than twice its time to buy one. As an A&P and military mechanic I never cared on the price that I paid for a...
  15. J

    Need info on Bucking tool? Rivet work.

    look for a hand squeezer it might be more helpful of you doing copper.
Top Bottom