Recent content by JFSmith

Hi, I live in Somerton, Ohio about 20 miles from Egypt Valley, so we are near BFE, Ohio:shocking: . I am a metal artist, that makes jewelry and large sculptrures and everything in between. The wife and I used to live in the capital city of Ohio, I can no longer remember the name of that...

Make a bending jig on a piece of wood and metal posts, then heat the rod up and bend it around posts and you should get a nice bend if you go slow. Jerry

I just cut one and put new ends on it, otherwise I look at places who have ready made. I ran air through the ceiling way of my garage put cuts in where I have the over head reels. Jerry

I am wiring my garage for 200 amp service to run my mill, lathe and TIG welder, and it is costing me a lot!

I have been able to get a Sears charge card at K Marts for a while. By HF tools they have a better warranty. BTW I am new to this forum, thought I'd say Hi. Jerry