Recent content by jhasafety1

I bought this to cut 95 outlet boxes out of the OSB I put up on my shop walls and ceilings. it worked very well and extremely fast. My cutouts looked very professional. https://www.amazon.com/dp/B00YX8KZGO/?tag=atomicindus08-20 I used an oscillating saw to make the cuts.

Run a dehumidifier.

I bought the 3/4 yellow gasline pex, 2 steel uprights and two couples from Home Depot and it all worked great. Installed in the trench in about 35 minutes. I sleeved it under the driveway in 2 sewer pvc pipe. I did have to put in a regulator at the house because I ran almost 90 feet. The pipe...

When I use to pressure wash houses I would use Simple Green on the stain and pressure rinse.

I did a 32" tall crawl space for my woodworking shop with Fox Blocks. Worked out very well. I braced with 2x4's around the inside. We didn't have any issues and poured a 30x40 crawl space in about an hour. I would hesitate to do a bigger project. Just have lots of help.

I did 2400 sq ft of the Cortec Plus over a year ago, really holding up well.

Usually the reporting quantities on diesel and hydraulic fluid are at 55 gallons. So you most likely don't have a reporting requirement. I would scrape it up to get it away from the well and if you can get the microbes mix them in, and spread it over a larger area away.

Thanks for updating us on your cost, I waiting for the rain to give me a window to start the dirt work. Your post have helped me through the decision process.

How much did the complete building cost?

When I used to hang gutter we used left handed offset aviation snips. We also carried right handed for when we had the occasional odd cut.

I would also check below the floor to see if there is a pillar carry the weight to the ground. If it is load bearing I would put a header in from the far right side of the door and carry it left to the corner.

You need to have it disposed of properly. It can be inhaled and absorbed through the skin. I love the advice that is given here and you have to wiegh its value when you take it. People only know what they know. so if they don't know facts they can be dangerous. Use your best judgement and be safe.

We use the same glue traps that you would use for mice to catch the brown recluse spiders. Also works good for crickets in the fall. I have been told that spraying requires the liquid gets on the spider, they do not pick up the residue like other bugs. Spray then keep glue traps out in hidden...

I used the roll on bed liner you can buy in the gallon can at local stores. I coated the underside and 5"-6" on sides and back and the front of the toe kick. These were the cheap cabinets made out of particle board. No problems after 4 years.

We always went with 4' on trusses and 8' on posts.