Recent content by JHB

Well, I decided to see if I could actually polish the chrome after removing the oxides/scale. I used 000 synthetic steel wool with a citrus degreaser as a lubricant, then Auosol metal polish and a microfiber towel to finish the job. Here is the same box end 18mm wrench.

Here is a 1/2'' drive socket that I received last month. It is worth saying that snap on has been great, and returned the defective socket(s) (there were three) without hesitation. Here are my thoughts: 1. This is a clear visual defect, how would three sockets from the same set all make it...

Correct, I wrapped various abrasive pads around the handle to remove the scale on the inside of the smaller box ends. I also use it for detailing the interior of my vehicles (air vent slats, around radio buttons, etc.).

Thank you for the replies. The entire wrench is submerged in the bath. Anything else would be impractical, as it required to conduct current and would be impossible to control wicking. I realize the wrenches are suspended from one end during the process. None the less, I had a look at some of...

I realize that they will work just fine, this is more a question of principle. Is this a normal condition?

I just ordered several new sets of wrenches from snap on, and I'm not impressed with the chrome. These are new, part of a master set in foam, never been used. Thoughts?