Recent content by Jim greengo

What is the voltage on the coil/contactor youre using?

It should've been spinning from the time it was dumped in the truck.

Dewalt of course! I will now retreat to my bunker under a non descript barn south of Omaha. Hahaha

Cord is supposed to come through the hole in side/end of motor.

Line of site is normally good enough. So you can see the disconnect while you're servicing the equipment.

It's a glorified window ac, what did they actually do to the old one? Tell em if they want you to trouble shoot it yourself you wouldn't need a freaking warranty!

Around 125 is supposed to be the highest I can set them locally as a plumber anyway.

Is it connected with a whip?

I was taught to always burn an inch , as my dear old dad called it.

My tape measure doesn't go down that low. Hahaha

Laundry needs to run independently to a 3" in omaha anyway.

I wonder if heating up the material with a torch after sand blasting it would help pull the moisture out of the material? Then primer it after it after it cools down.

You didn't get all the rust out of there. Did you use the rusty metal primer or regular?

Aren't the holes in the cover sealed by foam or something?

Can you turn the box?