Recent content by JimmyOdass

Thanks for the insight!

Nice! I have the same saw on the Rigid rolling stand. It has a little more wobble than I would prefer. I switched to the folding leg stand by Dewalt that came with the saw. Would the Dewalt rolling stand be more stable than the Rigid?

Finished the last phase of garage organization with some overhead storage above the bench and peg board.

Knocked out two out of three garage projects I've been wanting to do, a workbench and pegboard. I carried the pegboard beyond the workbench and nearly the length of the wall, because my full-size truck goes on the right side of the garage and there wasn't much room for anything else in front of...

Knocked out two out of three garage projects I've been wanting to do, a workbench and pegboard. I carried the pegboard beyond the workbench and nearly the length of the wall, because my full-size truck goes on the right side of the garage and there wasn't much room for anything else in front of...

Thanks for all the feedback! I'll look into this and do some experimenting. I

Yes, we have a heat pump with aux heat.

Thanks for the responses! I did check out beestat.io. Very easy to work with. I will analyze the data and see what trends and possible explanations I can come up with. Thanks!

Yes, I believe that is correct.

We have two stats on one furnace. Each stat has a sensor. For example, the second floor stat is in the master bedroom. A sensor is connected to it and is located in a room over the garage which tends to be a little colder. The main floor stat is in an office closed off from the rest of the of...

I recently moved into a two story, basement home with two ecobee thermostats controlling an electric furnace, one on the main floor and the second on the second floor. I set up a schedule which set the low temperature threshold lower when we are likely not home and higher when we are. The smart...

Do you find your non-sliding miter saw to be limiting? I like them, because they are more compact and can be placed closer to a wall. I'm not sure whether I'd need a sliding miter saw.

I picked it up as well! I think mine was about $22. I really like the measuring tool. I tried to use the level for installing curtains rods. After two sets I'm not sure how helpful it is for that, but I'm sure I'll find other uses.

I was lucky enough to snag one of these. It's a great opener! I had to show the cashier a snapshot of a receipt someone posted to Slickdeals to get it for $87.50.

I appreciate your trolling! I bought the Bosch laser measuring tools for $70 last week.. I was able to price match to $22.** today! Thank you!