Recent content by jimxwill

Yup. Found a whole cart. 102 cans

So......I found a penny deal

And it's out of stock. Let's see if they give me a refund.

Just realized they didn't send the kd side cutters I ordered. Ugh

Too far. Salem NH and Seabrook are close

Idk who lives near Haverhill Mass but they cleared out the two store near me..

Just build an attached garage with doors straight to the driveway. She be able to easily pull in, you can put a 9ft door to get the Jeep in. Heck, you could make it tall enough to put a 2 or 4 post lift in. Packed gravel next to the garage for boat and jeep parking. Leave the small garage door...

What's the return value of the batteries?

I was trying to weld 1/4", voltage was all the way up and the spied was at 50%. In that case should I slow down the wire speed?

Well... voltage was at 11. Speed was at 5

Surprisingly little out there in the century 130. Can't even find the manual. Tomorrow I'm going to turn the speed down to 25% and try again

Guys, I need help. Garbage picked a century 130 mig welder two years ago and finally started messing around with it. Got a gas set up, new ground wire and clamp, etc. My welds look like terrible,but I've also got under an hour of welding under my belt. Any advice?

The real question is how well the building is air sealed. No sense running the AC when it's just going to leak outside

Snagged that Klein wire cutters screwdriver combo for $10ish. No signage, just hanging with the electrical tools

Very interested