Recent content by jmoser87

I'm not.sure what's going on here or why it's 2 license but when I have it running I have that little tab down ,then lift it when I am about to shut it off to let it idle. But I should only have to close the valves for.it to idle "unload itself" right. And as for inside the unloader I replaced o...

I found one not acdelco though none of the numbers.i found on the unit brought anything up on Google

So when I go to hook up the linkage how should I do it carb to governor linkage wide open 1/16 or what ever it is off the stop pin ?

Hopefully these help

Thanks ! So which number is my actual part number ? Cause the on inside the pump is just for the bottom bowl part well at least what I read

66 Chicago pnematics tow behind air compressor, with the continental f163 in it first I need a new fuel pump or rebuild kit anyone know where to get one from? And secondly I need some help with the governor idk if I'm missing a spring or not on it

Yeah that's what I was hoping thanks now I need to figure out these filters

It will basically be like this with less 3/4 pipe legs going to where I need the air the 1 1/4 will be the bold line then the 3/4 will be the faded line

I kinda understand the chart but wouldn't it be less I'll have far more in the 1 1/4 for the look part the 3/4 drops are just to go where I need the air at. I wouldn't need no 100 ft of 3/4 I'll probably need about 30 to 40 ft of it depending how high I wanna have the 1 1/14 stuff off the...

So 1 1/14 main and 3/4 drop or 1 inch drop?

3/8 mostly

The piping is **** I had there already with my DeWalt 60 gallon so I knew I have to change it up just wasn't sure about piping. I just kinda recently got this tow behind and was just dealing with the pressure drop till now.

I will also need to take into consideration that if I wanna do this full time then I'll be getting bigger sand blasting equipment also

It's a harbor freight blast cabinet nothing fancy probably just hook my pressure pot up to it when I need little stuff done

Oh ok from the first couple of comments I thought I needed bigger drops. I'm still new to this stuff and still working out the kinks on this old compressor with no manual which *****.