Recent content by Joe_K

Insulation is already blown in, walls are finished, walls are insulated. Doing surface mount conduit, so I guess I'll have to hang the lights from chains.

Thank you!!

Did some more reading again. The previous fixtures recommended were 12445 lumens. The link belowis 13,000 lumens so I should be fine. Trying to figure out if they can be surface mounted. Been a while since I was doing research...

I was thinking of getting these. https://www.ledlightingwholesaleinc.com/H5-160W-XYZ-p/h5-160w-xyz.htm

Need a little help. Life took over and running electric to the shop got put on the back burner. It's happening this spring and I'm ready to order but this link doesn't work and I don't remember the specifics. Any chance you could help me out? If not I'll just select something I think will work.

I did not. I left a gap and glued vinyl cove trim to the bottom. Plenty of flexibility. There's a chance I went overboard, as my concrete has not budged in over a year, but that's how I did it.

Thank you!!

Thanks!! And yes, conduit.

Still using extension cord power. Hung up some cheap Amazon lights. Hoping to run electric in the spring. Sent from my iPhone using Garage Journal

Sent from my iPhone using Garage Journal

It’s a bit of a mess right now, but I did finish painting. Sent from my iPhone using Garage Journal

No, but the bottom plate is only attached to the concrete, not the posts.

The Appalachian Trail runs along the top of that mountain just north of I78. I don't think I would've done anything different. Maybe a man door along the back wall. We have a lot of yard behind the shop and a fire pit. I haven't been on here for a while. Didn't get as far as I would like...

Honestly, I don't think the foam board is necessary. R23 Rockwool has this building sealed up tight. If you run heat more than AC, the vapor barrier should be on the inside. I used staples and taped the seams.

I don't remember the exact amount, somewhere around 3 grand.