Recent content by johnHarley

Thanks will do

Question on GFIC outlet the dock motors can't be hardwired directly from the 220v breaker in the sub panel is that correct it has to go through a GFIC outlet with a 220v plug in is that correct?

Thanks got an ohm meter and will add a second if needed you have been very helpful

The dock shed is about 8' from the sea wall on solid ground. Then there is 8 foot wide dock beyond the seawall; the boat house and lift will be built out from the dock

Thanks, had not thought of GFI I was thinking as in a house any outlet closer than 6' required a GFI outlet. Lift motors will be 20'+ from subpanel so regardless of distance they need GFI protection? Is dependent on location of motors to water source ?

New to forum: posted these question on a much older thread. I will be helping my son run a line ~100' from his main 400amp house panel to a 100amp square D 8 circuit sub panel at his dock storage shed. Thinking of using MHF 2224 and burying it 18" in 2"#40 conduit. Use a 90 amp breaker in main...

Thanks I will start my own thread Sorry