Recent content by joker2607

Hii all, after replacing the card, the machines shows the same fault code 02. The cable is ok. After I turn the key to platform control the joystick lights blink and then turn of. What should I do, my machine is out of order now for 20 days, please anyone?

The machine has outriggers. I tried to connect the wires directly to the board but it's impossible, then i searched for the trace where would they be connected and I found the 1,2,4, but the 3 and 5 no luck. The wires on the other end go to the connector which goes to ECM. redmondjp if you...

Thank you all again for helping. This is the scheme of my controler http://postimg.org/image/6p7huvsdt/ I know how the wires go but if you look at it carefully on the scheme i can't figure out where do these holes connect to(holes 3 and 5) it says here PIO3 PIO4 PIO5 but I don't know what are...

Thank you all for the answers. The serial number of the machine is: GS90-40619. I already studied the service manuals and they don't go that deep in the problem. I found that a jack on the PCB was broke so i dettached it and tried to connect the wires directly but i don't know where two of the...

Greetings to you all, I have a huge problem with my lift. The machine is: Genie GS 4390RT from 2001 Motor: Deutz History: The machine had a few tweeks with switches which I replaced and It was working fine until one of my colleagues while expanding the platform ripped the joystick cable...