Recent content by JonathanLaporte

OLD motor: 63 pounds New one: 33 pounds! I have a 20amp breaker with the right wire.

Well I think the old motor was a more or so 3/4 and the the 10.8 is a real one.

Ok I forgot to had, the old 1950 brunner engine broke... the stator is starting to shows some broken fins... Little bit like that: http://globuselectric.com/images/mtrfail_str07-f.jpg So I don't know how to rebuild it. I found a good recent motor for 20$ and bought is... might reset the...

Going from a old 1950 brunner motor 3/4 hp 1725 rpm. 8.8amp 115v/230v TO 3/4 hp 1725 rpm 10.8amp 115v/230v LEESON motor. Will I see the difference in the power and fill up time?

Old motor 8.8amp 3/4hp 1725rpm 115v new one: 10.8amp 3/4hp 1725rpm 115v :D So my engine should have more power right?

Ok i've done many test... 1- interal engine has been damaged (Mark on rotor etc.) Also this motor dosn't have bearing... WHAT?!? Its riding right on the shaft! Tried a new capacitor and still the same problem... Anyway I found a good working 3/4HP engine on kijiji for 20$ I'll give it a try.

Might need some further investigation. You file are not accessible right now... might be a MBR problem. The MBR is the système that manage all the partition on a disk. If you can install the softwar called "Team Viewer" I could remote connect tonight and see what I can do remotly. Thanks.

I'm an IT technician. 1- is the HDD sprinning. If not then the problem is with the HDD motor. If YES: 2- Is it clicking? If yes, problem might be with the head or PCB board. You can put it in the freezer for a few hours and then plug it back in and try to access it. 3- If NO CLICKING, then...

Hi guys. I have a brunner compressor and now it's starts to act funny. When I start it it blow the breaker after a few minutes... I can hear the motor slow down and speed up again etc. Now I'm quite handy with mechanic stuff but need a ha nd with that motor. On the top if it these some...

Here's the facebook page: www.facebook.com/CarbSonic I know its all in French but I swear I'll post bilingual stuff as well. Please like and share. Thanks.

9Hi Guys, I don't know if I'm allowed to post this here but if not please let me know admin. I'm starting to do more and more caburator cleaning. So I'm buying a big ultrasonic cleaner to fit the needs. Here's what I can offer the members : I'm located in canada, quebec. I have a 500mm x...

Id love to. Any website you recommend with tips?

Thanks for the tips. I'd love to have some more if you have some.

Installed my new compressor. Tried my Harbour freight powder coating gun.

Happy I gave you the idea