Recent content by jordantii

  1. J

    Anyone have a problem with there Sam's Club tool chest rusting..

    Have had mine for over 4 years here in humid Florida. No rust at all. Functions like the day I bought it.
  2. J

    trouble with milwaukee 18v batteries

    How did you rebuild the battery pack?????
  3. J

    Could of swore there was a link, pressure bleeder

    I made one from the link you are looking for. That link is dead. Just buy one for 30 bucks. It will cost that much to make in time and materials. http://www.motiveproducts.com/ Jordan
  4. J

    Makita Impact Driver

    I have the cordless Milwaukee impact gun and it is all I use. It will break lugs torqued past 96lbs/ft without breaking a sweat. I take it to the track with me with 2 bateries and all of my friends change their tires as well. Only problem was the original batteries died. I replaced both about a...
  5. J

    trouble with milwaukee 18v batteries

    Sounds like the battery pack is bad. I had a similar problem. The light would not come on. I put in a known good battery and the charger worked fine. Battery is dead. This is not uncommon with MW batteries.
  6. J

    In the market for a chainsaw

    A long Time ago when I was in grade school I used to help out my neighbor who was a lumber jack. This guy had about 5 saws including an eight foot Alaskan Saw Mill. This is a portable saw mill. His saw of choice was Jonsereds. By far the finest quality saw produced. They are not cheap but are...
  7. J

    Stainless hardware use ????'s

    My first post and have been lurking for a while. My local ACE has a huge selection of hardware including SS you may want to check them out. Not sure of the grade though. Best, Jordan
Top Bottom