Recent content by josh+audi=happy

https://vimeo.com/141351508 Sent from my iPhone using Tapatalk

Well I've blasted with a spot blaster with it and it works pretty well. I can't complain. Next step is a smaller aftercooler then the one I have mounted on the cage which I'm going to blast and paint, a then a few blast cabinets for small stuff and different medias. I'm saving my big...

Had it up to 125 so far Sent from my iPhone using Tapatalk

Yes but just went out and bought a photo sensing tachometer and amp meter Sent from my iPhone using Tapatalk

It works Sent from my iPhone using Tapatalk

Both sides of the left side is off. Going slow with it all. I had a lot of parts off it and have to loctite and check things plus I'm tired after the day job. Sent from my iPhone using Tapatalk

The right side is working so far: Sent from my iPhone using Tapatalk

In the garage now. Might be running this week: Sent from my iPhone using Tapatalk

Rain is sucking, but I've kept it wrapped up pretty well. I've kept the electrical stuff off it but it goes on and comes off for mock up. It's going in the garage somewhat soon. Stage 1 is getting running and stage two I'm going to flip the high pressure connections and plumb it into a...

I ditched that aluminum service 90. Too much thinking because I thought it make life a little easier but was a pita with the solid ground copper wire. Baldor is wired: Sent from my iPhone using Tapatalk

Not mine but looks like 8 gauge and is a 7.5hp setup Sent from my iPhone using Tapatalk

31amps on the motor plate, 40amp mag start specific for 7.5hp compressor motors. The mag start can accept up to 6 gauge wiring. Based on this photo? I'm alright? All the photos I've looked at (there are few online) that have 7.5hp motors and mags look like they have 8 gauge wiring. Sent...

I had the Day off from work so I've been wiring up the baldor. 8 gauge multiple strand wire in 1/2 conduit with a solid strand ground. I had extra from the flooring business so I made it work and didn't want to buy 3/4" fitting and tubes. Sent from my iPhone using Tapatalk

8 from the motor to the mag starter looks fine Sent from my iPhone using Tapatalk

Yah I'm pretty content with it so far. Still debating whether or not to remove the fin paint again. I need a new 3m EXL wheel for my baldor buffer if I get it soon I'll probably do it and also timing on when these gaskets come here. Anyone feel free to comment? 6 or 8 gauge from the...