Recent content by jp_over

LXCam, Thanks for the update and info. I also got confirmation from Ascend Tools that the hex bits fit. I'm ordering a few of the slim trays today for the legion of hex bits floating around my tool bag and work area.

How are these holding up long term? I found the current supplier here: https://www.ascendtools.com/Organizer-Genie-Four-Pegboard-Set-for-Tool-Organization-Gift-Item.html Also, it looks like the hex bits just fit direct without any clips. Is this the case? I called the supplier but...

Thanks for the additional feedback. I roughed up a quick scaled version to see where the doors would work well. I figure at least 2 large doors will let me get some air flow. I'm still working out all the equipment locations but this is the big stuff for now.

Thanks for all the good advice and feedback. It's been a while but we're just now getting ready to pour the slab. Bones - I'm not a big keeper of things but do like a good bit of room to work which includes all the shop work for running a small hobby farm (small engine repair, basic...

Thanks for all the feedback; much appreciated!

Good info - thanks Mike.

Friends, I've mostly used shovels only when digging up stumps but want to add a pry bar to avoid abusing my shovels. Any advice on which would work better? An added benefit would be flexibility for other uses/jobs. 1) 1-1/4″ x 60″ Pinch Point Crowbar...

Great info; much appreciated. MOwens - good to know, thanks

LS6 & ard, Thanks for the tips. The pictured carabiners are load rated/swing set versions (If I recall 1,000 lbs +). Are these generally considered bad practice? I could go with something like this if so (1/2" stainless quick link)...

This is from the receipt. Not sure on all the details/abbreviations but I did verify that it would fit a standard HDG bolt. 1/2-13 NYLON INSERT HVY A194 GR.2H HDG AF = 7/8 TH = .440 +/- .020

Update, on a long shot I e-mailed these folks and they offered to sell me a small batch of 1/2" hot dipped galvanized (13 thread) nylon insert lock nuts: https://www.lok-mor.com/products/prevailing-torque/n-loc/ Minimum order was $25 so I just ordered a few extra and am all set.

Thanks all for the fast feedback. Stainless would be great but then I'd have to replace the bolts as well. I'm going with the double nut / jam nut solution so I can have the option of disassembly when it's time to take the swing set out of service. Much appreciated.

Friends, In the attached photo, I’m looking to use a 1/2” locking nut. The problem is that these are not readily available for hot dipped galvanized bolts. The wood is western red cedar so hot dipped galvanized is the most economical fastener solution but I’ve been unable to find a standard...

+1, would also be interested to hear any updates.

Good info - thanks!