Recent content by Jschara

Dawn detergent.

Do It Yourself. Home made.

No cleaners. Just warm water.

I made a DIY ultra sonic cleaner to wash motorcycle parts. I had already had the engine cases bead blasted so I wanted to make sure all the media was throughly washed out of the cases. I had washed everything twice house hold detergent. Wanting to make sure, I put a case in my home made...

Problem Solved. I re- did the connections with solder. Must have been a loose connection. I wished I had done this from the get go. Thanks to all who responded. I appreciate your time spent on my problem. Cheers, Jim

I will test the marker lights to see if they are good. Thanks for the tip.

I ran the ground wire from the plug all the way back on each side of the trailer as to eliminate the need to ground to the frame. I thought that was the best way?

Thanks Cobbler for the response. Like I said the ground is from the car plug. The bulbs a new led. Actually the whole wiring harness and fixtures are new. I don't understand how the grounds can be mixed up because all white wires are to white wires. I ran the brown wire across the trailer...

I could use some help with my trailer wiring. From the plug I ran a white wire on each side back to the tail lights. Using the car plug as ground. Then I ran a green & brown wire back to the tail lights. I connected White to white on the tail light and brown wire to brown wire on the tail...

Problem solved! I bought a Skat-Blast gun. Works like a charm. Thanks to all who replied, Jim

I'll give that a try. I have tried every thing else. Thanks

Media is new and dry. I also fitted a valve with a water separator.

Plugged the nozzle with finger and still no go. Air pressure at 40-60psi with dry media. ?

Thanks to all who replayed to my post. Unfortunately I'm still getting nothing. I have replaced all the hoses. Built and installed a metering valve. Installed a valve with a water separator running at 60 psi. Have plenty of air. Am using crushed walnut as media. It is new, clean and dry...