Jsf721's latest activity

Thanks for the replys. You guys gave me great ideas. I will unload the shed this weekend and explare the damage and the feasibility of...

Looking closer, I'd be willing to guess that your floor is, even worse, osb rather than plywood -- not that either would have a chance...

Probably easy enough to cut the wire inside the shed near where it enters the shed, Jack it up, install the 4 x 6s and then install a...

Oof. If appears to be set directly on shaded damp ground, with no air circulation underneath. That is trapping dampness underneath...

I'd be tempted to put solid PT decking (5/4 x 6) over that gravel. You could top it with standard ply to close the gaps between boards...

Disconnect it and then extend the wiring with a junction box. I think slapping plywood down is a bandaid, at best

I would be tempted to jack it up and slide some pressure treated 4 x 6s under it.

Looks like significant rotting in the door framing already. I'm still trying to figure out why the door was mounted with that...

its got electric going to it so i am not sure how jacking it up would go?

I’m not home but found these on my phone. The shed was built on a stone gravel base. The floor lasted 3-4 years. It’s regular...

You'll need 6 sheets, right? That will run you over $400 right? You could have a concrete floor if you poured a bit over one cubic yard...

My local HD carries 15/32 and 23/32. I'd do the thicker and make sure to run fasteners rated for PT. How wet is it under the...

How to get air flow ?

What’s the best readily available pressure treated ply wood for a shed floor. How thick ? Shed is 9’x13’

that is a basic spade / blade connector Amazon