Recent content by jsmith6752

I often consider using aluminum soffit. I like the look but not the price.

Thanks for your input. I really want to use metal but it's a little pricey.

I just saw fiberglass corrugated panels for sale online. Has anyone tried these? I have 24" on center rafters. Metal seems a little expensive for me. thanks

I am getting ready for my 2 part clear coat. Any tips or suggestions? I am curious as to why it is suggested to use a paint pan versus pouring small amounts on the floor. It took me 2 weeks with stripper and razor blades to remove half my floor and etch it again. (hardener problem) I am hoping...

I did not know that material was in existence.....thanks

:( thanks

I am stripping half of my new 2 part epoxy floor. (100% solids) I am not happy with the appearance. I am chemically removing it and etching again. I plan on running tape down and stripping to the edge. i can then run a wet edge when reapplying . Will that be very obvious ? It will also get a 2...

wow...great article thanks so much I was sorry to see they have stopped production for upgrades

I rented an enco floor grinder today. It had the cutting blades on it. I tried it on my bad section of epoxy floor. It was a waste of money. It melted the surface a little so I added water which seemed to help a little. My suggestion is not to go that route. I am curious if the diamond stones...

Has anyone used this stripper before? I also found a new product called ronjohn. I will be stripping 1/2 of my new floor due to hardness issues. Would it be wise to etch the floor again? I hope that at least one thing would go right. What a battle this has been thanks

I did use the the suggestions on the tape . Thanks

makes perfect sense...thanks

I am in the process of epoxy coating my 30 X 44 pole barn.The cure time on the pour is close to 2 months. I tried the etch the other night with poor results. I went with the recommended ratio but it feel short on my power troweled floor. At least I only tried it on part of the floor. I found a...

I need suggestions on epoxying around trench drains in my floor. Would it be best to cut around them with a brush? If any material gets over coated I assume you can't just pull off the tape after the floor dries. I also have about 6 1 1/2 " pipes that are floor level coming up vertically. I may...

thanks.......appreciate that