Recent content by Jthenry

All done. Thanks for this amazing website and all of the resources and people within. Very helpful! For anyone reading, I live in Phoenix. The biggest problem I had with the primer coat was that it seemed like the pot time was cut in half. I finished the first cost a little too slow, it took...

I appreciate your responses! It’s all ready, applying first coat Saturday, second coat Sunday, and clear coat shortly after. All of this depending on any set backs. I’ll share a pic for SAG. Just caulked around the outside with a concrete DAP caulk and am all ready to go. Just need to dust...

Another question.. is one epoxy coat and a clear coat sufficient or do you think I should do 2 epoxy coats (1 and then sand it, cure and apply number two) AND THEN a clear coat? It’s a small garage, meant for one car, low traffic

As far as floor attachments for a shop vac, do you mean a rigid brush attachment? Or something that can pick up the flakes easily?

The floor is neutralized. I then rinsed it, careful to not push the acid into the floor and after it was rinsed I pressure washed it three times with a 3000 PSI washer. I ran my finger over the floor, it’s about the same as 100 grit sand paper. No debris or dust comes off either. Appreciate...

Hey guys, newby question here. I apologize if this is in the wrong section. I’ve recently etched my garage floor with muriatic acid. It went really well. I am about to apply the rusteum epoxy shield DIY kit. I had a friend tell me that I should apply the epoxy, lay the chips, razor the chips...