Recent content by jurickk

  1. J

    Shop Build

    Yep, that solves my problem exactly! It's a nice reassurance that you are planning properly when a product exists to solve a problem you are working on. I also like your earlier idea about the floor enamel and I was planning on using pressure treated ply for the floor. Not a bad idea, will...
  2. J

    Shop Build

    This will be the difficult part. I'm thinking I will use the sawzall to cut the nails at the joint and hopefully then I can drive them out with a hammer and a nail set from the bottom. He did stain his and I will likely do the same. Thanks. I'm on very sandy soil so I am nervous about this...
  3. J

    Shop Build

    Bumping this to see if I can get some new eyes on it.
  4. J

    Shop Build

    To cover the plywood floor, I was thinking about seeing if I could source some used linoleum flooring from craigslist. I don't really need anything fancy, just to keep a smooth surface that is more resistant to wear than plywood. Thoughts? I know there is a whole flooring section of the forum...
  5. J

    Home made steam/hot water washer

    I use one of these to shower while camping. Good water pressure and when I had the heat cranked up all the way I damn near scalded myself. http://www.amazon.com/gp/product/B000TXOJQ4/?tag=atomicindus08-20
  6. J

    Shop Build

    Also, for the interior walls, I am considering expanding on this guys idea of using pallet wood. I think it would make for a pretty sweet look in a workshop. I have plenty of time to think about this though as my build will not even start until spring.
  7. J

    Garage Size and Doors

    If you're parking two vehicles, my vote would be two doors. Mostly because it gives a guide for where to park so you don't encroach on the other spot.
  8. J

    New guy from Indiana

    From just north of Fort Wayne. Found my way here researching a shop build I am working on, hoped I could get some help from you guys. I'm a software engineer by day, but none of my hobbies involve a keyboard!
  9. J

    Shop Build

    Hi guys, first post here, so go easy on me! I have very quickly grown out of my 2-car garage/shop and have been working on a solution to this problem for the past 6 months or so. I've decided that I need to build in order to have room for all of the appliance type tools I have acquired (table...
Top Bottom