Recent content by Justin8888

Thanks Yea I already know the HF tumbler is too small, I figured it was a cheap way to test the finish. If it works well, I'll either upgrade or outsource. It looks like plastic abrasive media (pyramids/cones) might work well. Most people have the same reaction when I tell them I bead blast...

I make small delrin parts (2"x3") that I blast with glass abrasive then bead to a matte finish. Im currently working with the smallest cabinet that redline makes. It pulls like 5cfm through I believe a 4mm fixed nozzle. The problem is, the process is really slow, and I have a lot of parts to...

Basement shop, absolute worst case I could set it up in my detached garage, but it's unconditioned and it's cold out there right now

Cabinet: http://www.redlinestands.com/catalog/shop-equipment-c-327/sand-blast-equipment-c-327_501/sand-blast-cabinets-c-327_501_502/redline-re22-benchtop-abrasive-sand-blasting-cabinet-p-1690 CH...

I have a project that will require blasting some small plastic parts. I picked up a very small redline blast cabinet with a fixed nozzle that only requires 5 cfm. Now I need to pick a compressor to run it. I'm looking at the California air tools 15gal 2.0hp rated 6.4 scfm and the cambell 20gal...

Hi all, I have a need to blast some small machined delrin parts (about 2"x3"x1"). I was looking at this redline re22 cabinet...