Recent content by justnutsandbolts

I hope you have better luck with this product than I did. I'll post a 1 year review soon.

Do you have a birdseye view of the property? For trailers, I like drive-through setup. I'd prefer 16' wide doors, roll up doors or ones that are angle rise, 4 post lift along with 2 post, more than 24" room on the sides for cabinet storage, lean-to on both sides.

I have 5 heavy duty stronghold cabinets at $600 each. Some very light surface dust on them. Located in 08054, NJ They are exactly like the one in this link: https://www.globalindustrial.com/p/double-shi-storage-cabinet-60x24x78?infoParam.campaignId=T9F

All sold

Buy used and save. Where are you located?

6'x3' Hallowell Made in USA Wood Top Workbench & 43"x43"x1.25" Steel Welding Table 200 for the workbench tables (They have some holes for a vise) 550 for the steel welding table on casters

For minimal shadows I recommend 4 bulb t8 fixtures with led tubes. You can find the fixtures free or next to free. Easy to convert the fixtures to accept LED bulbs. Bunch of videos on YouTube I recessed mine. https://www.garagejournal.com/forum/showpost.php?p=8849817&postcount=4

Still working on the spreadsheet. I promise I'll post it. I got lucky with pre-covid lumber prices. 2x4x8 sells for $7ish near me. I bought them for around $3.54 about a yr ago.

Thanks for the comments. Although I accepted the fact that it is a floor, I am realizing that Hellfire was a mistake, it is scratching easily and the fact that my concrete was soft is not helping the cause. Next shop will have PEI5 tile. I am still trying to figure out cabinetry. I am...

I ordered 2 sets of the 12piece set from Costco on sale at $1499.. man I really do not like these. I buy & sell used Vidmars on the side and I regret not just going that route. I did not realize that the bamboo top comes in two 48" length pieces. My plan is to not use the tall cabinets to...

Can't you tint the windows? Here is how I solved the visibility issues under the lift: Stickymatch, I would equally space the light fixtures and have at least one right over the engine bay area. Don't make a calculation of $100-200 difference, just install more lights if you can. Lighting...

Recessed round LEDs are terrible for garage application unless you use a lot of them. I did a LOT of research on this topic and went with recessed troffers (qty 4 of 4ft T8 LED bulbs). For the same light output, I would have needed over 100 recessed round lights. Cost would have been much...

That's the ceiling I was going to do and would have been a huge PITA with my recessed troffers.

Why plywood ceiling vs drywall? What was the cost of this?

Sir... This is "garage" journal.