Recent content by k-os

Thank you to Lwlobo! Got some good looking beers, a heavy duty porcelain coated sign, nut drivers, and some stickers to add to my kegerator! Looking forward to trying the beers.

I see my victim has received theirs (I think just 1 of 2 packages) and mine just got delivered yesterday (I think).

Just got mine mailed today.

Last item for mine got delivered today. Will be putting together tomorrow and getting it shipped out.

I think ABS would be the closest for an entry-level type printer. You can print this on entry-level consumer printers with the addition of an enclosure to hold heat. Check out some videos on Youtube about PLA casting. It may be just what you need.

Count me in again!

I miss-spoke a bit when referencing the V2, at least for the original Aquila. There is an Aquila X2 out now that includes a filament run-out sensor and carrying handle, but probably not worth the extra ~$40 compared to the original Aquila in my opinion. I was originally looking at the Ender 3...

I have a Voxelab Aquila that I've been really enjoying. Basically an Ender 3 V2 Pro clone with some slight updates. They're around $160 USD when on sale. I'm running custom firmware on mine that allows me to run a manual bed mesh, although I do have a BLTouch that I haven't installed yet. I also...

Same here.

Thanks for the post. Worked for me!

What about applying a garage door threshold to the exposed area? https://www.amazon.com/dp/B00008WFT7/?tag=atomicindus08-20

Looks like it uses a taper fit. Extend the quill and use a drift through the bottom slot seen on part 22 to knock the chuck out. https://www.searspartsdirect.com/model/271imlyl2y-000247/craftsman-351226150-drill-press-parts See pictures not too far down this page for an example...

For those looking, note that these are 2700K temperature, so will be pretty warm/yellow.

I believe any venting that terminates horizontally requires CatIII stainless vent pipe. The heater installation instructions/manual should specify what is required.

I'm a fan of the Huot cases for drills bits and taps. https://www.amazon.com/dp/B00206DTB4/?tag=atomicindus08-20