Recent content by Kakivak

  1. K

    Craftsman Drill Press Information Belts, Bearings, Chucks, Keys, etc…1946-1984

    Very informative and well laid out. This is super helpful. Is 1/2hp sufficient for most drill press work? I have seen 1/2, 3/4, 1, and 1-1/2hp. Did the commercial models run beefier motors? Thank you
  2. K

    Need an electrolysis power supply

    Anyone ever try a tool battery charger? Dewalt, Milwaukee, skil, ryobi, etc.?
  3. K

    DIY hot tank - rust removal by electrolysis

    I'm going to give this a go on a vise. I'll post some pics. Before and after and what not.
  4. K

    The Unofficial Vise Parts Swap Thread.

    Looking for a main screw for 975/955 Parker vise, or thread/member info if anyone has replaced with aftermarket material, thanks in advance:beer:
  5. K

    New from Mississippi

    Thanks for the add. I've been reading many forum discussions from internet, and I'm glad to read as a member now. :bounce:
See more
Top Bottom