Recent content by Kamn

If you are running the pipe along the wall, you would need to ensure that the space it is in will not freeze the pipe. Also, if you are running a new line on an interior wall personally I would run Pex as it can deal with freezing better than copper because it can flex and expand, whereas copper...

Cant wait to see you get started on this one I have always wanted one of these Alfas.....the body lines are just great, wonder how it would do with a small V8?

The chart I just looked at showed a 1-1/2" line for that supply run of 75' I have an 80,000 btu heater in my garage and it called for 1-1/2" at 110' long Use the yellow PE pipe And what he said^^^^ about calling your NG supplier to make sure your meter can handle that much.....you may need to...

I type a little slow when I was typing there was only one response

I think he was asking for guidance on dollar figures The numbers you are looking for can be higher or lower depending on what the trades are charging. But you can get your self a ball park figure by calling the trades and getting estimates on the work you plan on doing. Add in the amount that...

I have a small kit from this company http://www.techtirerepairs.com/products/tire-repair-kits/ They were our supplier for plugs and patches at the tire shop I worked at, their plugs work great and are also warranty approved by some of the manufacturers Never had one fail or leak

And if you don't like other peoples opinions don't read anything on the internet Your signature line says it all

I thought he asked a direct question what can I use to braze brass to stainless........end of question the what, where, and why is all because people are nosey If you don't have an answer then do not reply And why the hell is this thread still going......end it already

sounds like a chipmunk trapped in there

Have you checked other forums for guys that could do it for you in your area?? Like, Chopcult.com or Dotheton.com Lots of other bike guys out there have the equipment to do this minor fab for you Hell, if you lived closer I would do it for you

Danscobra6, thats a sweet little ride you have there.......fuk em if they call it a fake. I would rather have yours than an original, would feel bad laying into the original and constantly be worried something would happen to it and then never really enjoy it. Your looks like you built it and...

Yes I think they are called Future buildings Sorry no number but I get their ads in my mailbox a lot and had friends price out kits

Do what you feel is right, no one else here is making payments on your new car and I for one would be pissed if this was my "new" car and I had to live with this POS afterwards. Its a simple no brainer of giving you a new car for the leaky one you have now.

AnthonyJ124 has given you the best info you could have......get in touch with the Regional Manager from the Manufacturer in regards to warranty and claims. A friend of mine was this exact person for Honda/Acura here in Canada and she had the final say in vehicle replacement and customer...

I always replace the solution after I clean a set of carbs Its just water and simple green........and after you rinse your carbs off with fresh water, I also give them a shot with carb cleaner out of the spray can because if you don't rinse it well enough there will be a mild form of...