Recent content by kamracer1

Thanks lomonte! Steevo, I was thinking I would do something like what I have drawn here. (see pdf). On a side note, I discovered my IR motor, part #322886 31 for the 2475N5 is purpose built and will not spin backwards without getting deep into the windings. So I'll be getting an alternate...

Lomonte, If you could give us the details and post some pics of your conversion, that would be great.

If you look at the first picture, you can see the 1/4" line snakes back behind the pressure switch. Then in the second picture you can see the line terminating in a 4-way fitting that also has the check valve, relief valve, and pump line. The third picture of my dad's 2475N5 I added for overall...

Steevo, Your project looks great! I have a couple questions. My dad's 2475 has an unloader tube that is activated by the pressure switch. I noticed yours doesn't have that. How are you making the gas unloader work for your setup and did you end up blocking off the hole where the throttle cable...

Hi everyone! I am new to the group and would like to reply to this thread because I am just starting on the same conversion. Mine is a 2475F12.5g Kohler. I am planning to use a 5hp single phase IR motor that I have off a 2475N5. After some investigation, I have discovered the project is not...