Recent content by Kcaps9

These are no longer made in USA, fyi, probably why it's so cheap now

20 in stock at 44221, for 6.98 each. Good price?

Thanks everyone for the advice, I picked up some wire brushes for my drill and it's working great

It's a smaller vise, 3 and a half inch, I have a bench grinder but figured the vise was a little small for that as there's a lot of small crevices Id need to get into For the Dremel wheels should I use a brass brush or the stainless steel?

Bump

Hi folks, long time lurker, first time poster I just bought an old usa made columbian vise, and it has some surface rust I wanted to get rid of and polish and repaint the entire vise. I have access to a dremel tool, but not sure what bits I should use to remove the rust without damaging the...