Recent content by Kevin Hager

Here are some shots of the finished installation, I was worried about the drain line making that long horizontal run, so I ended up, dropping it straight down through some PVC right after it exited the 1st curved section of conduit. I ended up picking up three studs on the outside mounting...

I’m not worried about noise so much, it is a shop/rv garage so not like I’m going to be sleeping out there. Just curious why do you wish the other two were on a wall?

No I didn’t, but I don’t have much of a choice if I want to mount it on the wall, I mean it’s already there. I figured if I hit the studs I would be ok.

Today I added some leftover trim boards running horizontal, the two lower pieces is what I now plan on mounting the main horizontal bracket, picking up 3 studs after removing the level and drilling a hole in the center. I will probably go to Lowe’s and get some slightly longer lag bolts to pick...

That looks like a lot more heavy duty set up than I bought off Amazon

Getting ready to mount a Senville 24K mini-split (130 lbs). on a wall that has hardi-board siding. I wish the mounting bracket was a little longer, but the plan is to slot the end mount locations apx 1/2 inch outward to allow me to pick up the studs which are on 16” center. The trim pieces...