Recent content by kimper007

Thanks for all the responses, I am pretty sure I am going to buy a Hobart, Lincoln or Miller in either 190 or 210 or 220. You guys are great and give good real world advice without being a$$ holes like other sites. Thanks again and I will keep you updated on my purchase.

I am looking for something that will weld everything from sheet metal up to 5/16. I have my garage wired for a welder with a 50amp breaker but I am sure I don’t need to go that big. I like to work on snowmobiles, cars and anything else that runs on gas. I am 42 and work in the mining industry...

I am in the market for a mig welder and was curious what was everyone’s thoughts on them. I am not looking for a 1000.00 piece because I only plan on using it every once in a while when needed. I have looked a Hobart, Lincoln, Eastwood, Miller, and even some Harbor Frieght models. Does anyone...

I would pay to get a epoxy floor, a friend of mine stated a company up in Minnesota and I helped him out for a year or so and have found that your choices are endless when it come to color and patterns. Plus they are very durable and clean up very easy. I can’t post a link yet due to not enough...

I live in northern Minnesota and just built a 30x40x10 with R21 in the walls and R 60 in the attic. I ran tubes in the slab for in floor heat (which is not hooked up yet) and 2” pink foam under the slab. I just installed a reznor 60btu heater and it works great especially with the 5 degree temp...