Recent content by kminnick

Thanks for all the input. I think I will do it as it is cheap and now is the time before the drywall is up! :)

Hi guys- I have a 40 X 60 steel shop that has 6" of insulation sandwiched between the steel siding/roofing panels and the perlins and girts. In one corner, I have a ~8x8 bathroom framed, wired, and plumbed. My question has to do with insulation. Since the outer wall has 6" of insulation...

Hi guys- I have framed in a 8' X 8' bathroom into my 40 X 60 shop and looking to tips on plumbing it. The rough floor plumbing was done when I had the foundation poured. I have a well, so will be plumbing in 2 - Bosch water filters. I also plan on plumbing in PEX-A, but this will be my first...

Hi guys- I have a 40 X 60 shop that's a steel building. I'm trying to figure out how the best way to wire in my LED (4') panels. I'm guessing I would have to somehow hang 3/4" conduit from the perlins and have 4" boxes with 4 plugins / box. My walls are 14' and the center of the building is...

This is my Curtis 180 gallon tank driven by 10 HP motor. I think it puts out something like 36 CFM... It was a backup compressor for a factory that had a IR screw compressor. They ran it occasionally to keep it operational. It's a beast, but I only had to give $700 for it!

Acid granules? I have the acid in the bottle and some white stuff in a bag???

I'm getting ready to do a 2400 sqft shop. Did you neutralize the floor after your etch? Was there enough etch in the kit, or did you buy more muriatic acid? Thanks,