Recent content by Ksem89

I found the logo. Its 1920s to 1940s. The logo is the weatherhead company logo from Cleveland ohio. The hammer appears constructed professionally, so either weatherhead made, or a machinist made it using weatherhead stock part from a tubing tool of some sorts. This hammer did come out of the...

I did find one other example of this mark, but it was also a mystery. I also found an electric company who made tools, non sparking hammers etc and their symbol is an M in hex with an arrow. Search continues! K

Upon closer look, it seems an arrow is going through the W, which I guess it could be flipped and be an arrow going through an M. K

Hey guys, I have this 41 ounce brass hammer that I'm trying to identify. The only markings on it are a series of Ws in hexagons on the handle. Chat gpt thinks either wright, or jh williams. Have you guys seen these markings? Thanks! K

It is 24" inches wide. And that makes sense as to why I cannot find a stamp. Thank you!! K

Hey guys, I picked up this box full of tools on auction. The best I can figure is it's a KR-23. However I cannot find the model number/on it. Can anyone do positively identify the model, and maybe date? Thanks!

Thanks Don! I'll leave this socket be lol. I already wire wheeled the whole breaker bar 😬. Imm just go wet wipe up the area and hope I survive. K

Hey guys, I run across a lot of tools that have this oxidized grey look to them. I'm curious if this appears to be cad? An sk socket that I found attached to a snap on ns-15 breaker bar which looked the same. I already wired wheeled the bar 😬 , then I noticed the "G" code meaning wartime...

Awesome! Thank you. I wasn't sure because the other Harrold pliers say 'harrold' on them. K

Anybody recognize these? H on the handles.

Hey guys, just wanted to share a little project of mine. Picked up this 1942 71-15, pretty ugly and had a broken tooth. I used the repair kit RKRA972. I had the original brass switch, which I was determined to use. So it took a little customizing with the new switch , but I got it! Had to...

I here ya on the castors. Im looking, Harbor freight did not have them. Seems the heavy duty 5/8 11 thread is hard/expensive to come by! thanks for the suggestions, keep em coming. k

Hey guys. I was given this industrial workbench. It's very heavy duty. 60 in wide and 29.5 deep. I am trying to figure out a good set up with it. Should I throw a spare vise on it? Or make it a grinder and buffer wheel station? I do mostly automotive work, home building projects (I have a...

Found some AN crowfeet, largest being 3" K

It wasnt so bad. Drilled one end and punched it out. Used an old bolt as the new piece, peened the ends, and replaced the spring. Works great now. May do it again to make it a little more seamless, but for now its good. Dont have a use for it anyways, just wanted to see if I could fix it...