Recent content by kshome

Welcome! I just joined a day ago myself. It is a really solid group I needed advice on some hex bit's and this forum was awesome helping me.

Thank you to everyone I truly appreciate all the great feedback! It will prevent me from using a low quality torx again. I just love the scout leather co copper driver. Ended up going with it in copper with Wiha bit's ( http://www.scoutleatherco.com/product/hex-bit-driver-round-shorty )...

Nothing huge but a little bit of 3D printed organization. One for holding hex bits, and the other for pocket knives.

I use this one when working on AR's. Has a AR-15 lower vice block. Also have some soft plastic teeth hanging on it with magnets in case i use it on anything easy to scuff up.

I love my Arlo aswell they are great for certain aspect's. With wireless I used a extender and it is great to be able to move camera around in very little time. I have also done the wired route, it was a pain compared to wireless but yes it is nice no battery to worry about. Make sure to...

Lol yes it is. I was searching for a hammer to use and really liked this somewhat comic hammer. Ended up being pretty easy save as jpg/upload. Was not size issue or compression needed so very happy!

The one I learned it on was a Benchmade Super Freek.... so yea expensive lesson. Knives are one of my hobbies I really enjoy lately. My EDC has been my Boos Blades Smoke.

I thought about them they seem to be using micro bit's but a good driver. If i go to the 1/4" hex bits there are a lot of great driver's. It is expensive but man I am about to push the button on scoutleatherco brass driver. And get full set of Wiha from amazon. Only problem I have thought...

Thanks guys for all suggestion's. I am thinking of spending a little more then I was and get a scoutleatherco copper driver. I just love the look of that driver. I am trying to decide if I go with scoutleatherco driver set of ( T6, T7, T8, T9, T10, T15, T20, PH#1, PH#2, PH#3, SL4.5, SL5.5...

I recently had a learning experience with taking a knife apart. I used a Craftsman T6 size screwdriver and it bent and made one heck of a stripped screw. I am about to order a set of Wiha bits for these small torx sizes. Is there any other brands I should consider or is Wiha going to give me...

Testing size of avatar picture

I have a outdoors cat it does a pretty good job roaming around house. But still a few just lately have made it. I have tried glue trap's and got one. I'm currently looking for better solution.