Recent content by Ktnewcom

Got a leaking hydraulic line on my lift. It's a 3/8 line with flared ends and fittings. It bends super easy so I'd imagine it's aluminum, but I guess it could be a soft steel. Any ideas on brick and motar locations that have the parts? I'm planning to assemble and flare myself, but I'm having...

You got me with that upside down arm! When I dropped it to its lowest position then I realized that the arm needed to be flipped. You're also exactly right about the arm extension just being bar stock. Looks like it was flame cut and not really cleaned up much. On the other end they welded a tab...

Just went to measure the holes again and all four are right at 29 mm or 1.15” :headscrat

Link to pictures of lift: imgur.com/a/CHxFQuJ Recently picked up a used 9k lift that is mostly complete, save for some small parts. Hoping that someone here can help with possible sources or solutions. It looks like a fairly old lift, made by Stern MFG Co. - Model WRL-9. Not sure who makes the...

You were correct. I guess I thought the pot was more sensitive. :lol::lol: anyway thanks for the speedy help, outlaw!

Thanks for the reply, and link (some nice info/photos)! I attached a picture of the board that came from the TM (apologies for lack of quality. It's from my phone) Basically I've hooked up the controller to AC power and attached the speed pot. When I turn on the power. The motor starts but...

Outlaw, I'm hoping you can help me with the wiring of an MC 30 board. I have (what appears to be) the exact board as you have pictured, along with the speed pot and motor from the original treadmill. Where I'm having trouble is the 4 connections next to the SCR, and labeled A-, A+, AC2, and AC1...