Recent content by land308

Carl has a selection of Emmert parts for sale, good luck in your search Rudy CS Machinery 210 Lower Hopewell Road, Oxford, Pa. 19363 Voice: (610) 998-0544 Cell: (610) 662-5311 (I don’t check cell for messages!) NOTE: Hours by appointment! http://www.mprime.com/Emmert/index.htm

zkling wrote I paid 425.00 for it, i already have the 100 amp breaker so may as well as use it unless i can find my receipt:lol: thanks for the help

Zkling, It has a LN7 feeder and it came with two guns, the manual says you can scratch start Tig with it but I have never Tig welded before and i just got it primarliy for the increased power of the Mig and i wanted to try stick welding also. I didn't realize that these units wern't very...

zkling, thanks for explaning, my machine is a square top with a wire feeder on top, so I should look for a bank of capaciters when I remove the cover, I don't remember the manual mentioning PFC's but like you said it will be a good idea to remove the cover and give it a good once over, coming...

zkling, "Does your machine have the PFC's in it? If so you may want to remove them, especially for at home use." I am not sure what PFC stands for so I don't know:headscrat

All, thanks for all the help sorry for using the incorrect voltage, now off to buy a disconnect so i can get this thing hooked up and running..

Wyliesdiesel, The welder doesn't have a plug it looks like it was hardwired previously Socophreak, yes it's in a home, I already have the 100 amp breaker but not the disconnect or the wire yet my main concern was that a 100 amp breaker could take the place of a 90amp super lag fuse safely...

Hello I am looking for some guidance hooking up a used welder I purchased, up to this point I only had a small MIG setup but I got a chance to upgrade and purchased a DC-250 from a school auction. I have the manual and I am unsure what the superlag fuse translates into as far as the breaker...