Recent content by larbow

I have the COM connected with all the wires that are either white or bare copper in the breaker box. I found this web sight. http://ecatalog.squared.com/pubs/Motor%20Control/0140CT9201.pdf And looked up the mag starter that I have and followed the wiring diagram and it said to run the COM to L2...

Yes I'm using single phase. It has a 120v coil. I've got my power wires connected to L1 and L2 and a ground. I have a 14 gauge wire going from L1 to the line terminal on the pressure switch and a wire coming off the pressure switch to 3 terminal which then goes to the coil. coming out the other...

The wire that needs to go to COM should I run that back to my breaker box and give it it's own source. That seems to be my only loose wire that needs to be connected to something I think. It's connected to the COM and connected to nothing on the other.