Recent content by LCD

No one but my Son and I operate the lift.

Outlawmws, sounds like you built a fantastic rig, have any pictures?

Lifted the 1953 Dodge M37, removed the leaking oil pan then after cleaning the block and pan flanges replaced it with a new set of FelPro gaskets and bolted it back in place. Then washed off the rust stains from the spring packs, lubed and repainted. The lift columns are plumb, just look to...

Thank you for your reply Dr. Stan. I have looked thoroughly on all surfaces and nothing stands out or painted over. Just like to know in case I ever need parts/service.

Bought it for $500 recently and have not found a manufacturer's name although I suspect it is American made since one of the posts has a roll stamp that reads "CSC -USA. I recently had my Silverado up on it and found it operated perfectly. Next I will try my Dodge M37 as soon as the threat of...

I live in Pennsylvania and it is kept in my garage. Where are you and what do you want to know. It is a 1953 Dodge truck made for the US Army and is known by them as an M37

Drained both fuel and oil, refilled with fresh, removed and disassembled the carb to remove any accumulated dirt and varnish. I then cleaned the points and gave it a couple of pulls and it took off. it runs well with out a hiccup. The gen end is a Onan, the mil standard was built by Wisconsin...

Use a black top Lute which is designed to level paving material, works like a champ for what you need done. http://www.amazon.com/dp/B000A2KI50/?tag=atomicindus08-20

liquidh8, try this one: http://s109.photobucket.com/user/fortyfivelive/slideshow/Pole%20Barn%20Pics jaker10, lived in Havre de Grace, just across the river from Perryville for over 50 yrs., been there many times and know Frenchtown Rd. well, have also walked those same tracks as far as up the...

Told by who? Check local codes because they may be different in your area. The building company, Conestoga Building Inc. (CB) used 6"x6" nom. glulam treated posts which were OK'd by the township engineer who reviewed the drawings before issuing a build permit.

Well George, I am located east of Pa. Rte. 74 near the PECO power plant just off of Paper Mill Rd. Used to live in Havre de Grace but moved into Pa about 4months ago and wanted to empty my old garage, that's why I needed a new building. PM me and I'll give you my cell number if you are...

Yes, 14' walls, plan to install a lift behind the 12' door if I have enough height. Had the contractor pour that floor section 6" thick of 4000psi mix.

Yes Daniel, lets in a lot of light that is reflected around the shop by the aluminum insulation foil backer, see my build slide show here: http://s109.photobucket.com/user/for...%20Barn%20Pics upundown, thank you sir, my other garage was a 24'X24 conc. block structure was to small so when we...